Nolako materiala moztu daiteke laser bidezko mozteko makinak?

21. mendearen hasieratik, fiber laser cutting machine cut pipe have been continuously developed, laser cutting technology will be applied in various fields, and more and more suitable materials will be used. According to the different characteristics of different materials, the matters needing attention when using the fiber laser cutting machine are also different.

Altzairu estrukturala

Emaitza onak lortuko dira materiala oxigenoarekin mozten denean. Oxigenoa prozesatzeko gas gisa erabiltzen denean, punta-punta oxidatu egingo da. 4 mm-ko lodiera duten plaketarako, nitrogenoa presio handiko ebaketa prozesatzeko gas gisa erabil daiteke. Kasu honetan, punta-punta ez da oxidatuko. 10mm baino gehiagoko lodiera duten plakak egiteko, erabili laserrak plaka bereziak eta aplikatu olioa piezaren gainazalean prozesatzerakoan emaitza hobeak lortzeko.

altzairu herdoilgaitza

Altzairu herdoilgaitza moztea beharrezkoa da: oxigenoa erabiltzea, ertzaren oxidazioak garrantzirik ez duen kasuan; erabili nitrogenoa, oxidatu gabeko eta burruntzarik gabeko ertz bat lortzeko, ez da tratamendu gehiago behar. Estalkiaren olio-filmak taularen gainazalean perforazio-efektu hobea lortuko du prozesaketaren kalitatea murriztu gabe.

aluminio

Despite its high reflectivity and thermal conductivity, aluminum materials up to 6mm in thickness can be cut, depending on the alloy type and laser capabilities. When cutting with oxygen, the cutting surface is rough and hard. When using nitrogen, the cut surface is smooth. Pure aluminum is very difficult to cut because of its high purity. Only when a "reflection absorption" device is installed on the system can aluminum be cut. Otherwise the reflection will destroy the optical components.

titaniozko

Titanio xafla argonarekin eta nitrogenoarekin mozten da prozesatzeko gas gisa. Beste parametro batzuek nikel-kromo altzairua egin dezakete.

Kobrea eta letoia

Both materials have high reflectivity and very good thermal conductivity. Brass with a thickness of less than 1mm can be cut with nitrogen; copper with a thickness of less than 2mm can be cut, and the processing gas must be oxygen. Copper and brass can only be cut when a "reflective absorption" device is installed on the system. Otherwise the reflection will destroy the optical components.

Material sintetikoa

Material sintetikoak mozterakoan, kontuan hartu ebaketaren arriskuak eta igor ditzaketen substantzia arriskutsuak. Prozesatu daitezkeen material sintetikoak hauek dira: termoplastikoak, material termosetagarriak eta elastomeroak.


Post-time: 20-ek-28-20
robot
robot
robot
robot
robot
robot