Jenis bahan apa yang bisa dipotong mesin laser cutting?

Sejak awal abad ke-21, fiber laser cutting machine cut pipe have been continuously developed, laser cutting technology will be applied in various fields, and more and more suitable materials will be used. According to the different characteristics of different materials, the matters needing attention when using the fiber laser cutting machine are also different.

Baja struktural

Hasil yang baik akan diperoleh saat bahan dipotong dengan oksigen. Saat menggunakan oksigen sebagai gas pengolah, ujung tombak akan sedikit teroksidasi. Untuk pelat dengan tebal hingga 4mm, nitrogen dapat digunakan sebagai gas pemrosesan untuk pemotongan bertekanan tinggi. Dalam hal ini, ujung tombak tidak akan teroksidasi. Untuk pelat dengan ketebalan lebih dari 10mm, gunakan pelat khusus untuk laser dan oleskan minyak ke permukaan benda kerja selama pemrosesan untuk mendapatkan hasil yang lebih baik.

besi tahan karat

Memotong stainless steel membutuhkan: penggunaan oksigen, dalam kasus di mana oksidasi ujung tidak masalah; menggunakan nitrogen untuk mendapatkan tepi yang tidak teroksidasi dan bebas duri, tidak diperlukan perawatan lebih lanjut. Lapisan oli pada permukaan papan akan mendapatkan efek perforasi yang lebih baik tanpa mengurangi kualitas pemrosesan.

aluminium

Despite its high reflectivity and thermal conductivity, aluminum materials up to 6mm in thickness can be cut, depending on the alloy type and laser capabilities. When cutting with oxygen, the cutting surface is rough and hard. When using nitrogen, the cut surface is smooth. Pure aluminum is very difficult to cut because of its high purity. Only when a "reflection absorption" device is installed on the system can aluminum be cut. Otherwise the reflection will destroy the optical components.

titanium

Lembaran titanium dipotong dengan argon dan nitrogen sebagai gas pemroses. Parameter lain dapat merujuk pada baja nikel-kromium.

Tembaga dan kuningan

Both materials have high reflectivity and very good thermal conductivity. Brass with a thickness of less than 1mm can be cut with nitrogen; copper with a thickness of less than 2mm can be cut, and the processing gas must be oxygen. Copper and brass can only be cut when a "reflective absorption" device is installed on the system. Otherwise the reflection will destroy the optical components.

Bahan sintetis

Saat memotong bahan sintetis, perlu diingat bahaya pemotongan dan zat berbahaya yang mungkin dipancarkan. Bahan sintetis yang dapat diproses adalah: termoplastik, bahan thermosetting, dan elastomer.


Waktu posting: Jun-28-2020
robot
robot
robot
robot
robot
robot